ST-Enterprise panel

---

• Pre amplifier
  Amplifies the signal before most of the processing occurs.
  
  Declipper, Link error '10182' and AGC if Gating based on volume before Pre Amp is enabled ignore this setting. If you want to correct a too low sound card input level, use Gain instead.
  


• Post amplifier
  Amplifies the output signal.
  
  This slider amplifies the output signal with a value after all the processing has finished. This is in effect a volume slider. If the Simple Clipper, Advanced Clipper and/or Hard Limit output is enabled, this value should not be set higher than 0.00 dB (x1.0). Don't allow above 0 dB can be set to enforce this. Otherwise, to avoid distortion, make sure that the output bar display is never completely filled: Too loud output means that the sound will be distorted.
  


• Don't allow above 0 dB
  Limits Post amplifier at or below 0 dB.
  
  Normally, there's no good reason to set Post amplifier higher than 0 dB, except maybe when you're testing certain things.
  

Quick Adjust panel

---

Processing overview panel

---

Repair overview panel

---

Loudness panel

---

Simple loudness controls.

• Loudness
  Makes the sound louder or softer.
  

Texture panel

---

Simple texture controls.

• Attack/Release speeds
  Affects how fast the levels are adjusted, makes the sound more or less aggressive.
  


• Density
  Controls the density, makes the sound more or less aggressive.
  

Audio spectrum panel

---

Simple audio adjustment options.

• Lows density
  Controls the density of the low (bass) frequencies.
  


• Lows gain
  Increases or decreases the amount of bass.
  


• Deep bass synthesis
  Controls how much deep bass is reconstructed if it was removed from the recording.
  


• Mids density
  Controls the density of the mid frequencies.
  


• Mids gain
  Increases or decreases the amount of mids.
  


• Presence density
  Controls the density of the presence (mid-high) frequencies.
  


• Presence gain
  Increases or decreases the amount of presence (mid-highs).
  


• Highs density
  Controls the density of the highest frequencies.
  


• Highs gain
  Increases or decreases the amount of highs.
  

Levels panel

---

Input and output levels.

ITU 1770 panel

---

• Measure ITU.1770
  


• Reset ITU.1770 measurement